Because of their sizes, these

Because of their sizes, these www.selleckchem.com/products/10058-f4.html rod-shaped particles can serve

as light scatterers in the visible region of PARP inhibitor incident light, enhancing light harvesting in the resulting device [14, 15, 22]. Figure 1 Typical FE-SEM image of sintered ZnO film on FTO substrate. Figure 2 shows XRD patterns of the ZnO films before and after sintering. These two samples exhibited similar patterns except for differences in the peak intensity. Apart from those corresponding to the FTO substrate, the diffraction peaks can be indexed to the hexagonal wurtzite ZnO (JCPDS card no. 79–0206). No other diffraction peaks were found in both cases, indicating that the prepared ZnO films are of the pure wurtzite phase, and no phase transformation occurs during thermal treatment. The diffraction peaks of the ZnO film became shaper after sintering, implying that the thermal treatment raised the crystallinity of the ZnO film. Based on the XRD data, average crystallite size was estimated using the Scherrer’s equation: (1) where 0.89 is the Debye-Scherrer’s

Alvocidib supplier constant, λ is the X-ray wavelength (0.15406 nm), θ is the Bragg’s angle (measured in radians) at which the peak is observed, and B is the full width at half maximum. The crystallite sizes before and after sintering, as estimated from major reflections, were both approximately 20 nm. The results show that sintering did not have a significant effect on crystallite size. The estimated crystallite size matched the size of the nanoparticles in the film. Figure 2 XRD patterns of ZnO films. (A) Not sintered and (B) sintered at 400°C

for 1 h. The asterisk denotes the FTO substrate. Photovoltaic characteristics of fabricated DSSCs The performance of the fabricated DSSCs was measured under 1 sun AM 1.5 G simulated light. Figure 3 shows the dependence of various photovoltaic parameters on the dye adsorption time and the film thickness: J SC, V OC, fill factor (FF), and overall conversion efficiency. Ibrutinib Figure 3a shows a plot of J SC versus the dye adsorption time for various film thicknesses. Except for the thinnest photoanode (14 μm), where the J SC values decrease continuously with increasing dye adsorption time, the J SC values of the remaining cells exhibit a similar trend with the dye adsorption time: the J SC values first increase as the dye adsorption time increases, reach a peak value, and then decrease as the dye adsorption time increases. The initial rise in the J SC values with increasing dye adsorption time is likely the result of increasing dye molecule adsorption on the ZnO film. However, when the dye adsorption time becomes too long, dye molecules can aggregate on the metal oxide surface, reducing J SC[32, 35–37].

Comments are closed.