It has a wide-bandgap Alpelisib research buy semiconductor (3.5 to 4.3 eV), which shows high transmission in the visible wavelength (80% to 90%) and relatively high work function (4.7 eV).

The ITO glass substrates were supplied from Samsung Corning Precision Materials Co. Ltd (Seoul, Korea). PEDOT:PSS aqueous solution (1.3 wt.%) as a buffer layer material was purchased from Baytron® (Hanau, Germany). Zinc acetate dihydrate as a precursor material was purchased from Junsei Chemical (Tokyo, Japan). P3HT as an electron donor and ICBA as an electron acceptor were purchased from 1-material Co. (Quebec, Canada). 1,2-Dichlorobenzene and isopropanol as a solvent were purchased from Sigma-Aldrich (Seoul, South Korea). Monoethanolamine 4EGI-1 ic50 as additive was purchased from Junsei Chemical (Tokyo, Japan). Preparation of ZnO nanostructured fibrous film The pre-patterned ITO glass substrates were cleaned with acetone, ethanol, and isopropyl alcohol (1:1:1) for 1 h by sonication and then rinsed with ethanol. After cleaning, the ITO glass substrates were annealed at 230°C for 10 min in vacuum and served as high-work function electrode. ZnO nanostructured fibrous films were prepared by sol-gel

process in which zinc acetate dihydrate (Zn(CH3COO)2 · 2H2O) was added to a solution of isopropanol and monoethanolamine. The molar ratio of zinc acetate dihydrate and monoethanolamine was 1:1, and the zinc concentration in isopropanol was set from 0.2 to 1.0 M. The mixture was stirred at 60°C for 2 h to yield a clear homogeneous solution. After stirring, the solution was spin coated

acetylcholine at 3,000 rpm for 20 s on the pre-patterned ITO glass. The Birinapant order films were then dried at various temperatures for 3 h and then cooled to room temperature on a hot plate. The ZnO nanostructured fibrous films were observed under scanning electron microscopy (SEM; S-4800, Hitachi, Tokyo, Japan). The crystal structures of the samples were characterized using an X-ray diffractometer (XRD; D8 Advance, Bruker AXS GmbH, Ettlingen, Germany) with CuKa (k = 1.5418 Å) radiation. Device fabrication PEDOT:PSS was used as a buffer layer material and filtered using a 0.45-μm Millipore polytetrafluoroethylene syringe filter (Millipore Co., Billerica, MA, USA). PEDOT:PSS was stirred for 1 h and then spin coated on the ZnO nanostructured fibrous film at 3,000 rpm for 60 s using a digitalized spin coater (MS-A10, Mikasa Co. Ltd., Tokyo, Japan). The PEDOT:PSS thin films were annealed for 20 min at 120°C in vacuum to remove the water. After the annealing process, the devices were cooled down to room temperature. The bulk heterojunction active layer was prepared via solution process. P3HT and ICBA were dissolved in 1,2-dichlorobenzene in a weight ratio of 1:1 and concentration of 20 mg/ml solution. The blend of P3HT and ICBA was stirred for 24 h at 40°C. The blend of P3HT:ICBA solution was spin coated on the PEDOT:PSS buffer layer at 2,000 rpm for 60 s.