pH appeared as a flat line ( Fig. 2a), therefore, P0 could not be determined (dashed curve in Fig.

2a is calculated from the P0 in Fig. 2b). The assay was repeated with cell monolayers grown on Corning Transwell® polycarbonate membrane inserts. The log Papp at pH 7.4 was higher than the value obtained from assay using cells grown on Transwell®-Clear, and pH-dependent permeability was then observed ( Fig. 2b). pKaFLUX was detected at pH 5.9. The approximate log P0 was derived according to Eq. (A.12) and subsequently refined ( Appendix A). The results suggest that the polyester membrane with lower pore density (4 × 106 pores/cm2) than polycarbonate membrane (1 × 108 pores/cm2) restricted permeability of the highly permeable propranolol. I-BET151 datasheet The measured Papp data (black circles) for compounds of different chemistry: acetylsalicylic acid and phenytoin (acids), diazepam and lamotrigine (bases), leucine (zwitterion), caffeine, and dexamethasone (neutral drugs) were analyzed to derive P0, corrected for permeability through the aqueous boundary layer (PABL) and paracellular permeability (Ppara) ( Fig. 3). The PABL was determined using propranolol as marker based on the initial finding that propranolol permeability was limited by the ABL ( Fig. 2b). From Fig. 3a, it is possible to deduce that the permeability of acetylsalicylic

acid is limited by the ABL at pH < 4, based on the calculated log PABL of −4.40 (propranolol ABL marker) LDN193189 Ketanserin and the refined log P0 of −3.31 ± 0.01. Also, for acetylsalicylic acid, it was possible to refine the Ppara constant (−5.35 ± 0.01) using the measured log Papp vs. pH data. The refined Ppara constant predicts a TEER value of 286 Ω cm2 (Eq. (A.8), Appendix A), which is within the experimental error of the measured TEER of 345 ± 55 Ω cm2 ( Table 2), suggesting that log Papp for pH > 6 ( Fig. 3a) is consistent with paracellular permeability, and not predictive of an uptake process of the acetylsalicylate anion. The measurement at pH 8.5 was reproducibly higher than the model would predict, suggesting a possible increased paracellular leakage at pH 8.5. The data point

was ultimately assigned a zero weight in the refinement. A similar effect appears to have taken place with verapamil at pH 4.8 ( Avdeef et al., 2005). For all of the other molecules in Fig. 3, Ppara was estimated using Eq. (A.8), where TEER measurements were used to calculate Papp of sucrose, from which (ε/δ)2 was calculated (Eq. (A.11)) and applied to each of the drugs in Fig. 3b–g to estimate the corresponding value of Ppara during the refinement step ( Appendix A.5). These log Ppara values ranged from −5.03 (l-leucine) to −5.82 (digoxin). The permeability of caffeine (Fig. 3b), diazepam (Fig. 3d) and leucine (Fig. 3f) were not limited by the ABL. To derive the intrinsic transcellular permeability (P0) of the compounds, the log Papp vs.